Relative growth rate

Growth rate relative to size

Relative growth rate (RGR) is growth rate relative to size - that is, a rate of growth per unit time, as a proportion of its size at that moment in time. It is also called the exponential growth rate, or the continuous growth rate.

Rationale

RGR is a concept relevant in cases where the increase in a state variable over time is proportional to the value of that state variable at the beginning of a time period. In terms of differential equations, if S {\displaystyle S} is the current size, and d S d t {\displaystyle {\frac {dS}{dt}}} its growth rate, then relative growth rate is

R G R = 1 S d S d t {\displaystyle RGR={\frac {1}{S}}{\frac {dS}{dt}}} .

If the RGR is constant, i.e.,

1 S d S d t = k {\displaystyle {\frac {1}{S}}{\frac {dS}{dt}}=k} ,

a solution to this equation is

S ( t ) = S 0 exp ( k t ) {\displaystyle S(t)=S_{0}\exp(k\cdot t)}

Where:

  • S(t) is the final size at time (t).
  • S0 is the initial size.
  • k is the relative growth rate.

A closely related concept is doubling time.

Calculations

In the simplest case of observations at two time points, RGR is calculated using the following equation:[1]

R G R   =   ln ( S 2 )   -   ln ( S 1 ) t 2   -   t 1 {\displaystyle RGR\ =\ {\operatorname {\ln(S_{2})\ -\ \ln(S_{1})} \over \operatorname {t_{2}\ -\ t_{1}} \!}} ,

where:

ln {\displaystyle \ln } = natural logarithm

t 1 {\displaystyle t_{1}} = time one (e.g. in days)

t 2 {\displaystyle t_{2}} = time two (e.g. in days)

S 1 {\displaystyle S_{1}} = size at time one

S 2 {\displaystyle S_{2}} = size at time two

When calculating or discussing relative growth rate, it is important to pay attention to the units of time being considered.[2]

For example, if an initial population of S0 bacteria doubles every twenty minutes, then at time interval t {\displaystyle t} it is given by solving the equation:

S ( t )   =   S 0 exp ( ln ( 2 ) t ) = S 0 2 t {\displaystyle S(t)\ =\ S_{0}\exp(\ln(2)\cdot t)=S_{0}2^{t}}

where t {\displaystyle t} is the number of twenty-minute intervals that have passed. However, we usually prefer to measure time in hours or minutes, and it is not difficult to change the units of time. For example, since 1 hour is 3 twenty-minute intervals, the population in one hour is S ( 3 ) = S 0 2 3 {\displaystyle S(3)=S_{0}2^{3}} . The hourly growth factor is 8, which means that for every 1 at the beginning of the hour, there are 8 by the end. Indeed,

S ( t )   =   S 0 exp ( ln ( 8 ) t ) = S 0 8 t {\displaystyle S(t)\ =\ S_{0}\exp(\ln(8)\cdot t)=S_{0}8^{t}}

where t {\displaystyle t} is measured in hours, and the relative growth rate may be expressed as ln ( 2 ) {\displaystyle \ln(2)} or approximately 69% per twenty minutes, and as ln ( 8 ) {\displaystyle \ln(8)} or approximately 208% per hour.[2]

RGR of plants

In plant physiology, RGR is widely used to quantify the speed of plant growth. It is part of a set of equations and conceptual models that are commonly referred to as Plant growth analysis, and is further discussed in that section.

See also

  • Doubling time
  • Plant growth analysis

References

  1. ^ Hoffmann, W.A.; Poorter, H. (2002). "Avoiding bias in calculations of Relative Growth Rate". Annals of Botany. 90 (1): 37–42. doi:10.1093/aob/mcf140. PMC 4233846. PMID 12125771.
  2. ^ a b William L. Briggs; Lyle Cochran; Bernard Gillett (2011). Calculus: Early Transcendentals. Pearson Education, Limited. p. 441. ISBN 978-0-321-57056-7. Retrieved 24 September 2012.